Compatible with
concentrates
The atomizer on the device is Crystal Quartz and can be cleaned very easily. To clean the atomizer, remove the atomizer completely from the Oculus battery and submerge it in 90% ISO for a period of 1-2 hours. This will remove unwanted matter that has gotten into places it shouldn't. Air dry the coil after ISO submission. We recommend doing this fairly regularly to extend the longevity of your atomizer. Never put water in the Oculus atomizer.
Yes! New Quartz Crystal Atomizers can be purchased on our website at: https://www.kandypens.com/oculus-coil.html
To fill the glass, remove the glass from the battery first. Fill with proper water just above the two intake holes. Ensure device is held upright for best results.
To safely remove the glass, pull and gently turn the bubbler glass to separate it from the Oculus battery.
This is dependent on multiple factors such as frequency of use, preferred voltage setting, the Oculus has a 500mAh battery.
We recommend letting the Quartz Crystal Atomizer begin to heat your material before draws are applied. "Sesh mode" will run only at 1.8V for 30 seconds, and is used only as a "pre-heat" with this device. We recommend activating "Sesh mode" by pressing the power button 2X to preheat, then press and draw on your preferred voltage setting. Additionally, a slow and steady draw will help improve vapor production most times as well. Apply the atomizer tip to the outside edges of your material and slowly move inward to receive a more vaporous hit. If you need further assistance or have further questions about use and inhalation technique, please contact our customer support team.